Employing the Balanset-1A System Getting the Equipment Ready vibration sensors, optical speed sensor, magnetic base, software package, and included accessories. Connect the device to your PC using the USB interface and confirm the software installation. Mounting the Sensors Fix the accelerometers securely to the machine's structure in locations where vibrations are most prominent, ideally near the bearings. Position the laser tachometer (phase angle sensor) so that it is aimed at the rotor. Attach reflective tape to the rotor for accurate phase angle reading. Software Startup Initiate the Balanset program on your computer. Choose the correct balancing method (single or two-plane) according to the rotor configuration and the balancing task. Operate the rotor at its intended working speed. The application will acquire data on vibration magnitude, rotational velocity, and phase angle to determine the initial imbalance state. Mounting the Test Weight Stop the rotor and attach a trial weight at a specific location on the rotor. The weight's mass can be specified within the software (e.g., in grams). Restart the rotor, and the software will record the changes in vibration level and phase angle. Computing the Compensating Weight Based on the measured data, the software automatically calculates the correction weight parameters: mass and installation angle. The calculated values are presented on-screen in both numerical and graphical formats. Mounting the Compensating Weight Install the correction weight on the rotor according to the software's calculations. If necessary, perform intermediate checks to verify that the imbalance is being reduced. Validation and Conclusion of the Balancing Process Once the corrective weight is in place, restart the rotor and measure the remaining vibration amplitude. The balancing procedure is finished if the remaining vibration is within the permissible limits specified in ISO 1940. If the vibration level remains high, repeat the process with further weight adjustments. Creating a Balancing Report The balancing results are saved in the software's archive. You can create and print a report containing vibration data, correction weight mass, and its installation angle. Concluding Steps and Verification Verify the secure attachment of all balancing weights and measurement sensors. Ensure the rotor rotates smoothly and without excessive noise. If the rotor is part of a complex mechanism, verify the proper interaction of all its components. By implementing this method, you can effectively eliminate imbalance, reduce vibration levels, and increase the lifespan of the machinery. Instagram: https://www.instagram.com/vibromera_ou/ Youtube : https://youtu.be/guA6XJ-ArZM?si=vmkuX7RILzKBl0zL Our website about Balancing of straw chopper